This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.

You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

How to import mib rows inside solarwinds??

wrainwater over 5 years ago

So Im trying to generate an alert for my liebert UPS system to know when the voltage phases drop below a certain threshold. I was able to locate the MIBs using the universal device poller and found the following values:

I only need the first 3 rows and the last one. How can I import this in solarwinds and report it as an alert??

Top Replies

mesverrum over 5 years ago +1

A few ways you can do this. If you know that these are the only rows you need and they would never change order then you could set up separate UNDP pollers for 1.3.6.1.4.1.476.1.42.3.5.3.2.1.4.1, 1.3…

0 mesverrum over 5 years ago

A few ways you can do this.
If you know that these are the only rows you need and they would never change order then you could set up separate UNDP pollers for 1.3.6.1.4.1.476.1.42.3.5.3.2.1.4.1, 1.3.6.1.4.1.476.1.42.3.5.3.2.1.4.2, 1.3.6.1.4.1.476.1.42.3.5.3.2.1.4.3 and 1.3.6.1.4.1.476.1.42.3.5.3.2.1.4.7
Otherwise you poll the whole table and then set up an alert condition that filters against the rowid. There are more complex ways to do fancy things with custom SQL/SWQL if you think the row order would change but I doubt you need to go that deep for this case.
Cancel
Vote Up +1 Vote Down

Cancel
0 wrainwater over 5 years ago in reply to mesverrum

Thanks for your response. I created a UNDP for those values but can't pull them up in solarwinds. Is there a middle step to displaying them? Im using a Universal device chart
Cancel
Vote Up 0 Vote Down

Cancel
0 mesverrum over 5 years ago in reply to wrainwater

First, did you test them and make sure they returned values from your UPS?
If that was good, did you check the box that says keep historical data (can't chart it out of we aren't logging it over time).
Did you take those UNDP's and actually assign them to the UPS?
Hit poll now and wait a few minutes after assigning them, see if you have data.
Cancel
Vote Up 0 Vote Down

Cancel
0 wrainwater over 5 years ago in reply to mesverrum

Where do you see poll now? In SW or in Orion UDP
Cancel
Vote Up 0 Vote Down

Cancel
0 mesverrum over 5 years ago in reply to wrainwater

You would go to the node details for the UPS, its inside the management widget
Cancel
Vote Up 0 Vote Down

Cancel