This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

Advanced Alert issue

I am new to Orion so this is probably an easy question.

 

I wanted to monitor my switch interfaces for late collisions.  So I setup a custom poller for it and assigned it to the one switch I have added to Orion so far.  When I pull up the device view I see it on the device page and I see one of my interfaces is having late collisions and the numbers increase each polling cycle.

 

So I want to alert on this so I setup an Advanced alert with the following config

Poller Name is equal to dot3StateLateCollisions

Rate is grater then zero

 

and configured it to email on trigger (and tested email which worked).

 

I did enable the alert as well.

 

However, even though I see the LateCollisions increasing on device view, the alert is not triggering.   What am I missing?