cancel
Showing results for 
Search instead for 
Did you mean: 
Create Post
Level 9

NCM not showing Dell Firmware Vulnerabilities

Hello,

I have a few Dell S4048-ON switches that I backup in NCM. I just started getting into expanding capabilities and I do not see anything coming up in the "firmware vulnerabilities" and "overall policy report violations" charts. Is this possible for Dell S4048-ON's or are they only for Cisco devices?

Attached are print screens of the charts I am asking about.

Thanks,

Cole

0 Kudos
3 Replies
Level 12

The overall policy reports widget will only populate if you have set up policy reports inside of NCM. Below is an example of how that widget will look once you setup policy reports. You can also visit this to see how to create the policy reports.
Screen Shot 2019-08-27 at 1.54.02 PM.png

Firmware Vulnerabilities will populate for Cisco and Juniper devices, at this time, but there is a feature request you can vote on here about expanding vendor support.



jpetkevich Thanks. I went ahead and voted. I will work on the policy reports as well. Good stuff!

When I get the reports up and running, can it generate a compiled report - sort of like a vulnerability assessment report?

0 Kudos

You will see all of the Policy Reports on the Compliance page:

Screen Shot 2019-08-28 at 10.49.07 AM.png

Once you have the report it will look like this once it is completed:

Screen Shot 2019-08-28 at 10.49.26 AM.png

You can then drill into any of the statuses:

Screen Shot 2019-08-28 at 10.51.50 AM.png

0 Kudos