ISE enabled an interface

Question

Is there a way to have SolarWinds compliance check if ISE/802.1x is enabled on an interface and or build a report what would do the same?

chayden18 · Accepted Answer

I had to run a compliance check based on the config of each interface. Real simple to setup. This is my original post, and in the thread you can see what the configuration of the check looks like. You would just sub out the authentication host-mode auth-mode with what ever interface config you want to verify....i.e. dot1x pae authenticator

https://thwack.solarwinds.com/t5/NCM-Discussions/Automate-Interface-Config-with-NCM/m-p/583558#M22620

As pointed out by cnorborg here is an additional post that might help:

https://thwack.solarwinds.com/t5/NCM-Discussions/NCM-Compliance-Remediation/td-p/187399

Hope this helps.

ISE enabled an interface

Top Replies