This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.

You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

Configuring SW monitoring and alerts

rishabhwal over 6 years ago

Hi,

I am totally new to Solar winds and my client needs to use SW to monitor below metrics. I need to understand how it works and what kind of monitor I need to install for it.

VMware Memory Utilization

VMware Guest Disk Free space on the disk in percentage.

VMware VM CPU Processor Utilization

VMware Virtual Machine Virtual Machine Status

VMware VM CPU Processor Utilization

VMware CPU Container Total CPU Utilization

VMware VM CPU Processor Utilization

PROCESS PRESENCE Total Percentage Of CPU Used By Monitored Process

DISK % Of Time Device Was Busy Servicing A Transfer Request

SWAP % Swap Space Used

PROCESS PRESENCE Process Count

VMware Guest Disk Free space on the disk in percentage.

PROCESS PRESENCE Total Percentage Of CPU Used By Monitored Process

DISK % Of Time Device Was Busy Servicing A Transfer Request

VMware Memory Memory Utilization

VMware Virtual Machine Virtual Machine Status

VMware Guest Disk Free space on the disk in percentage.

FILESYSTEM % Filesystem Space Used

VMware Guest Disk Free space on the disk in percentage.

FILESYSTEM % Filesystem Space Used

PROCESS PRESENCE Process Count

VMware VM CPU Processor Utilization

VMware CPU Container Total CPU Utilization

DCM DCM Status

PROCESS PRESENCE Process Count

SWAP % Swap Space Used

PROCESS PRESENCE Total Percentage Of CPU Used By Monitored Process

FILESYSTEM % Filesystem Space Used

DISK % Of Time Device Was Busy Servicing A Transfer Request

KERNEL % Number Of Shared Memory Segments Used System Wide

KERNEL % Number Of Semaphores Used System Wide

VMware VM CPU Processor Utilization

DISK % Of Time Device Was Busy Servicing A Transfer Request

KERNEL % Number Of Messages Used System Wide

KERNEL % Number Of Semaphore Sets Used System Wide

KERNEL % Number Of Message Queues Used System Wide

PATROLAGENT Num Of Executions per Minute

PROCESS PRESENCE Process Count

PROCESS PRESENCE Total Percentage Of CPU Used By Monitored Process

0 nathan.hejnicki over 6 years ago

Most if not all of what you asked would be either natively available or able to be scripted with SAM (process/service monitoring, performance counters, etc of Windows and Linux/Unix are all in SAM's wheelhouse), but since you had a lot of VMWare counters in your list you're also likely going to need Virtualization Manager, which integrates with SAM quite nicely. Sorry that you didn't get any replies sooner- most likely because you posted this in the Network Configuration Manager section but asked questions pertaining to servers and virtualization.
Nathan Hejnicki
Loop1 Systems
Cancel
Vote Up 0 Vote Down

Cancel