This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.

You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

juniper router m7i/ex4200

sharon7000 over 12 years ago

Hello

I can not work with the juniper router

When trying to run thr cli.modify.config it gives me the following error message:

"device type: juniper.router has not yet had this functionality. skipping this device."

When I try to run the "cli.send.command" script With the command "show version" it gives me the following error message:

"the following command is invalid"

What am I doing wrong?

0 christineb over 12 years ago

Hi Sharon - have you checked out the supported activities list to see if your activities are supported by the device?

http://www.kiwisyslog.com/wrapper/devices-supported/

--Christine
Cancel
Vote Up 0 Vote Down

Cancel
0 sharon7000 over 12 years ago in reply to christineb

ok,
I understand that Modify Config is not supported by you,
but what about Send Commands?
The second part of my question is:
When I try to run the "cli.send.command" script With the command "show version" it gives me the following error message:
"the following command is invalid"
Cancel
Vote Up 0 Vote Down

Cancel
0 Spartacus over 12 years ago in reply to sharon7000

Which CatTool Juniper device type are you using?
The Juniper.Router device type should support the Report.Version table activity, so you don't need to run the commands via the Device.CLI.Send Commands activity.
Hope this helps.
Regards,
Steve
Cancel
Vote Up 0 Vote Down

Cancel
0 sharon7000 over 12 years ago in reply to Spartacus

and when i want to use the command :
"show vlans"
Out of ten times I'm running the command, I get a good output once
this is the bed output:
^
unknown command.

ss@SW-XXXXX> terminal len
^
unknown command.

ss@SW-XXXXXX> terminallen 0
^
unknown command.

ss@SW-XXXXX>

ss@SW-XXXXXX>
Cancel
Vote Up 0 Vote Down

Cancel
0 keitharaneta1 over 4 years ago in reply to sharon7000

I found a solution regarding the issue you experience wherein JUNOS is typing "terminal len 0" on the specified device but is not included on the cli send command
just need to Go to the device > variations > under additional commads tab > check disable paging and leave it blank . after that kiwi should not be typing any terminal len 0 on the cli
Cancel
Vote Up 0 Vote Down

Cancel