cancel
Showing results for 
Search instead for 
Did you mean: 
Create Post
Level 8

BW Gauge V9.0.4 Reading zeros out every 10 sec

I can't find anything about this issue on Thwack - I set up two BW gauges to monitor my Internet ports traffic, one port on each of two 2950 switches.  The ports are set with "load-interval 30".  No matter what refresh rate I set on the gauges, they seem to bounce back and forth between the real reading and zero!  This doesn't seem to happen with other port types on a 6500 or on a 720x router.

Has anyone else seen this behavior?  TIA

Paul 

0 Kudos
2 Replies
Level 17

It could be that those particular devices SNMP agents not updating? I'll need to research the 2950s more, however in later versions...
 there was a BW  issue that was addressed in SP1 for 9.2. In particular, some issues with the 2950

0 Kudos

Thanx, Mark, and this is not a drop-dead issue either.  Plus I just realized these are 2924 switches, i.e., one step above stone knives and bearskins.

I'll try 9.2 ASAP too.

Paul 

0 Kudos