This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Printer Question

Hello:

I just started testing the NPM. All devices seem to have been discovered and added but I keep getting "Node is in warning or critical state" on just about every printer in the network. We have a mix of HP Laserjet Enterpise M60xx and Lexmark MS610 as well a few color Laserjets.

Clay

0 dgarciam over 1 year ago

I'm also in testing mode this days. I see that by default there are a few conditions that triggers warning or critical which are not. I added 500 cameras, and all of them had a disk partition full. In this case is not critical since they don't hold video, but i can't see where to cancel this alarm for 500 camaras at once.
Cancel
Up 0 Down

Cancel
0 neomatrix1217 over 1 year ago in reply to dgarciam

You can remove the disks from monitoring in manage nodes so that you don't get those alerts
Cancel
Up 0 Down

Cancel
0 dgarciam over 1 year ago in reply to neomatrix1217

Hi. I'm trying to do this now.

Tried the "Edit Properties" and "Custom Property editor" while all selected with no luck.

I'm looking at "More Actions" and have a selections of actions to select.

Normally, i took a property out of monitoring listing the resources of the node, but the "List Resources" is grayed out when you mass select nodes.

Care to guide a bit more on this?

Thanks
Cancel
Up 0 Down

Cancel