This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can we alert for SNMP not responding nodes?

Hi all,

I searched about this topic but all are very old so wanna know if we can alert for nodes which are not responding to SNMP.

I have only 5-6 nodes for which alerting is required.

So can anyone help me on this?

We actually had an issue for some devices where they were found in hung state and they had reboot the device to bring to normal. So according to me setting up non responsiveness to SNMP will atleast meet this requirement.

Top Replies

Parents

0 pratikmehta003 over 7 years ago

Will this work, can you help me confirming?
Cancel
Vote Up 0 Vote Down

Cancel
0 smoked_angus over 7 years ago in reply to pratikmehta003

Good day, you may wish to consider "Unknown" and Polling Method as shown below:
Cancel
Vote Up +2 Vote Down

Cancel

Reply

0 smoked_angus over 7 years ago in reply to pratikmehta003

Good day, you may wish to consider "Unknown" and Polling Method as shown below:
Cancel
Vote Up +2 Vote Down

Cancel

Children

0 pratikmehta003 over 7 years ago in reply to smoked_angus

I think this should work for me...didn't know that stat Collection and polling method variables are also available. Thanks a lot :-)
I will try this and let you know....
Cancel
Vote Up 0 Vote Down

Cancel
0 pratikmehta003 over 7 years ago in reply to smoked_angus

one thing though..if i use the same setting but for ICMP then i think that will also alert me if the node has gone into unknown state.
Correct me if m wrong.
Cancel
Vote Up 0 Vote Down

Cancel
0 smoked_angus over 7 years ago in reply to pratikmehta003

It should work fine; of course Simulate against a node and get results before actual save.
Cancel
Vote Up +1 Vote Down

Cancel
0 pratikmehta003 over 7 years ago in reply to smoked_angus

Cool...
Cancel
Vote Up 0 Vote Down

Cancel
0 pratikmehta003 over 7 years ago in reply to smoked_angus

Hi smoked_angus
But I don't see any option of 'unknown' for Polling Method as shown by you, are you sure its the same? OR were you referring to Node status?
Cancel
Vote Up 0 Vote Down

Cancel
0 smoked_angus over 7 years ago in reply to pratikmehta003

Yes, it is there, with polling method.
Cancel
Vote Up 0 Vote Down

Cancel
0 pratikmehta003 over 7 years ago in reply to smoked_angus

Oh..k let me check..and alerting Wil be on Node type right?
On 05-May-2016 5:33 pm, "smoked_angus" <
Cancel
Vote Up 0 Vote Down

Cancel