IP address conflicts not work ( install IPAM only not used UDT)

I install IPAM only set the alert IP address conflict, remote change same IP address 2 VM and enable neighbor scanning to see arp table but not see IP address conflict and I check on switch show arp I see 1 MAC table.

Parents Reply
  • Ok.  It seems what you are looking at is SNMP neighbor vs. SNMP neighbor.  That is actually not listed on the IP Address conflict scenario.  My take here is that the IPs are getting conflicts but since you are only getting it from one source which is SNMP neighbor, it is not being detected.  You might want to send this over to support for further verification.

Children
No Data