1 Reply Latest reply on Aug 28, 2009 4:46 PM by Fodome

    Refresh values on rescan


      I have a switch that I just replaced however under the properties for that device, the Device Vendor did not auto update from Cisco to Dell.  How does the "Refresh values on rescan" work?

        • Re: Refresh values on rescan

          Hello Chaldz,

          These values are updated if and when the system is rescanned using one of the following methods:

          • Add New Device -> Rescan (when prompted)
          • Scan network -> Previous Scan results -> Select the Device and click Rescan.

          You can also manually update the Device's Properties by switching the "Property Refresh Policy" pull-down list to "Keep old values on Rescan" and then entering the desired values.

          Hope this helps.

          Chris Foley - SolarWinds - Support Specialist
          Support:  866.530.8040  |  Fax: 512.857.0125
          network management simplified  |  solarwinds.com