Real-time Netflow export not working with flexible netflow config v5 or v9 from 881W

I have configured a Cisco 881W with flexible netflow to export to my laptop running Engineer Toolkit v10.9.1.30.  The router is definitely sending netflow to my laptop ( i confirmed with wire-shark capture ).  I see the interfaces in the Netflow Realtime window.  I see traffic in and traffic out in the columns.  But it does not seem to take in the netflow traffic.  Wireshark can identify it as netflow v9 or v5, so I don't know why solarwinds realtime Netflow can't.  I also made sure to open up Netflow on 2055 through windows firewall.

The Flexible Netflow config looks like this:

flow record cascade-record

description Riverbed Cascade Gateway

match ipv4 tos

match ipv4 protocol

match ipv4 source address

match ipv4 destination address

match transport source-port

match transport destination-port

match interface input

match interface output

collect routing next-hop address ipv4

collect transport tcp flags

collect counter bytes

collect counter packets

collect timestamp sys-uptime first

collect timestamp sys-uptime last

flow exporter SW-export

description Export to Laptop-SW

destination x.x.x.x

source Vlan1

transport udp 2055

export-protocol netflow-v5

template data timeout 1200

option interface-table timeout 3600

option exporter-stats timeout 60

flow monitor Laptop-SW-monitor

description Laptop SW Toolset

exporter SW-export

cache timeout active 60

record cascade-record

interface Vlan1

description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$CVO$

ip address x.x.x.x 255.255.255.248

ip flow monitor cascade-monitor output

ip flow monitor Laptop-SW-monitor output

ip flow ingress

ip tcp adjust-mss 1360

service-policy input Classify_Inbound_COS

service-policy output QoS_Monitoring