Version 6

    NCM will work with any device that has a CLI interface where the commands are ran that is on the device template.

     

    You will not be able to use NCM if the device only has GUI as there is no device template that connects via GUI.

    Think of the device template as the commands that NCM will run on the CLI to download the configs.

     

    NCM will work with any device that has a CLI interface where the commands are ran that is on the device template. (Long story short: there are devices supported out-of-the box, there are templates on thwack, you can develop your own template.

    There is a very small group of devices that cannot be supported from principle -- typically low-end devices without CLI.)

     

    So before moving to the device template  again first to make sure the CLI interface and commands are available for the device to built the template.

    NCM config download basic requirements

    Creating a new NCM Device Template explained

    Other options Search on Thwack if there is other template available uploaded by community ?

    Settings > All Settings > Manage Device Templates

     

     

     

    NCM Device Template related questions

    List of supported NCM devices (Most common)

    Creating a new NCM Device Template explained

    Manage NCM firmware upgrade templates

    Create an NCM config change template

    Best practices for NCM device command templates

    Create device templates in NCM

     

     

    For any other questions please see this Thwack post

    NCM troubleshooting landing page