Access Manager - Generic Access Gateway.apm-template

Version 1

    This template is for NetIQ Access Manager

    Finally with their 4.0 release, NetIQ now support SNMP for monitoring of the various components of the Access Manager system.

    The MIB is part if the product install.

    The OID for each monitor points to an array that uses the IP address of the particular Access Manager component. So to make it easy to spot I used 200.200.200.200 for an example IP address.

    To use the template you will need to update each of the monitors and change the 200.200.200.200 to the correct IP.

     

    This has been tested against the V4 infrastructure although I have found that updating just the Access Manager admin console to V4 will allow V3.1 & V3.2 components to report via SNMP.

     

    Question or comments would be welcomed.