J-Flow Config

For the SRX-100H how as your performance been with this configuration?

Here is what Juniper says if anyone is interested: Juniper Networks - SRX Getting Started - Configure J-Flow - Knowledge Base

@bhavikdalsania

solarwinds-admin​

J-Flow Config  ​

Hello everybody,

could any one tell, what is the use of this config?

set services flow-monitoring version9 template NTA-flow ipv4-template

set forwarding-options sampling input rate 100

set forwarding-options sampling input run-length 0

set forwarding-options sampling family inet output flow-server 10.199.15.103 port 2055

set forwarding-options sampling family inet output flow-server 10.199.15.103 version9 template NTA-flow

set forwarding-options sampling family inet output inline-jflow source-address 10.199.2.35

set interfaces vlan unit 0 family inet sampling input

set interfaces vlan unit 0 family inet address 10.199.2.35/24

I have seen this config on my device juniper SRX320 branch firewall, but not applied to any interface as underlined in above config

My question is, what we get from this config? and how we could use this on solar wind GUI ?