JUNIPER SSG5 ( Template

Version 2


    Unfortunately Juniper Config Mgmt Command Templates are hard to find on THWACK content exchange. Therefore it's best to start publishing them myself. :-)


    Device: JUNIPER SSG5


    Status: verified and tested


    The following command template enables you to:

    1. Download config via "indirect tftp method" to a tftp server
    2. Upload config via "indirect tftp method" from a tftp server
    3. Download the config via "direct ssh method"
    4. Reset the firewall after uploading the config via tftp in order for it to be activated




    It is sometimes necessary to tell the firewall to use a different source interface. This can be achieved by adding the keyword "from interface", i.e. " from bgroup5/0.1"

    <!--SolarWinds Network Management Tools-->

    <!--Copyright 2007 SolarWinds.Net All rights reserved-->

    <!--created by Patrick Sigrist-->

    <Configuration-Management Device="Juniper Netscreen Devices" SystemOID="">


      <Command Name="MenuBased" Value="false"/>

      <Command Name="VirtualPrompt" Value="->"/>

      <Command Name="Reset" Value="set console page 0"/>

      <Command Name="Reboot" Value="reset${ENTER}ny" Delay="300" />

      <Command Name="Startup" Value="config"/>

      <Command Name="Running" Value="config"/>

      <Command Name="DownloadConfig" Value="get config"/>

      <Command Name="UploadConfigIndirect" Value="save ${ConfigType} from tftp ${StorageAddress} ${StorageFilename} to flash"/>

      <Command Name="Version" Value="get system"/>

      <Command Name="DownloadConfigIndirect" Value="save ${ConfigType} from flash to tftp ${StorageAddress} ${StorageFilename}"/>

      <!-- Juniper NetScreen Devices do not like Psuedo Terminal being allocated during SSH, so turn it off. -->

      <Command Name="AllocatePty" Value="False"/>