Get the latest news about SolarWinds NetFlow Traffic Analyzer (NTA)
My client is using SchoRen NMS Solutions, LLC Trapserver software for monitoring remote site for Generators (Running/Off, Overheating, Out of Fuel...ect), Open Doors, Lights at the top of Radio Towers to show when they are On/Off, operating, out, not flashing as well as Provider Power status for when there is power outage…
We are starting to monitor our network through a 3rd party without visibility to our SW during nights, weekends and holidays They will run strictly off of SW generated email alerts when a device goes down and will follow their guided procedures. I have set up most of the email alerts that they will need except this one. I…
I have been adding netflow to cisco devices and Solarwinds is picking them up automatically and storing the data due to a setting I have to accept unknown flow data. When I got to manager Flow source to see sample rate and manually select it to store data it states it has never received a flow for any of these interfaces.…
Does anyone use Netflow and NBARv2 with one another on Cisco IOS-XE? I am trying to figure out how to enable NBARv2 alongside IOS-XE. I went off the guide online http://www.solarwinds.com/documentation/en/flarehelp/netflow/content/nta-set-up-nbar2-on-a-cisco-device.htm but the command collection application name does not…
Hello All, Please suggest if we can monitor the traffic for these ports 80, 5009 using NTA. if not possible through NTA, please suggest tool which can help me in doing the same. Thanks.
Good Morning Has anyone configured a CISCO 9200 with the NTA? I need help with the switch commands to activate NETFLOW
When I install a new polling engine should i see a GUI for this ? Or, is this just a polling engine i will see from my main instance?
Comencé por agregar esta configuración a mi Switch cisco 9200 flow record NTArecord match ipv4 protocol match ipv4 source address match ipv4 destination address match transport source-port match transport destination-port match ipv4 tos match interface input collect interface output collect counter bytes long collect…
Hello, I have configured my cisco ISR router for netflow. I have used solarwinds configuration template for flexible netflow. I am only seeing outside flows meaning public IPs. The flows provided by the netflow are almost useless to me. I need to know the individual user traffic utilization. I have attached the below…
Hello All, Well , I have a cisco Switch 4948E and running policy-map on "vlan" or on "Interface Vlan" , or the physical interface itself vlan configuration xxxx || interface Te0/1 || interface vlan xxxx service-policy output CSTMR-TRMNL-POLICY Adding all interfaces / vlans to the CBQOS ( Netflow Sources ) does not result…
It looks like you're new here. Sign in or register to get started.