This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

Polycom SNMP v3 Auth fails

I am looking to monitor a Polycom RealPresence Group 700.  I have enabled SNMP v3 on the Polycom.  I have also tested the auth with MIB Browser from the toolset.  It passes the auth on read only.  Polycoms do not allow SNMP writes at all. I really do not want to use SNMP v1 if I can avoid it.  When setting up for the node to monitor the SNMP fails.  I am assuming on the failure to write side of things.  Is there any way  to setup a node with SNMP v3 auth but in a read only manner.

Thanks All