This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

Cisco 4400 Series Wireless Lan Controller

This template will allow Cirrus to pull down the running configuration file from a Cisco 4400 series WLC.  Once pulled down, it will be viewable within Cirrus.


Requirements:


1. Place attached file in "\SolarWinds\Configuration Management\DeviceTypes" directory


2. Close Cirrus if open, then open Cirrus


3. Change Device Command Template from Auto Determine to Cisco WLC


4. Verify that communication settings are set to telnet, telnet, telnet

Cisco WLC-1.3.6.1.4.1.14179.zip